News

Talking about the maintenance of non-standard reducer and the application method of hardened gear reducer

Updated:2020-04-11
Summary:1. Check whether the oil level in the reducer meets the requirements before starting the machine. Fo...

1. Check whether the oil level in the reducer meets the requirements before starting the machine. Follow the prompts to open or replace the vent cap to make venting smooth and see if the transition is active.

2. Before the load test, it is necessary to operate without load for about half an hour. It is admitted that the load can be loaded after no load failure. Test operation should always check the operation situation: there must be no abnormal impact, vibration, leakage or oil leakage. The temperature rise must not exceed 60 ° C, and the maximum oil temperature must not exceed 100 ° C (it should be checked regularly during normal operations).

3. If abnormal conditions are found during operation, the machine should be stopped for inspection, and the operation can be continued after the fault is identified and eliminated. Always check the situation of smoothness, pay attention to the amount of oil, and replace the smooth oil in time.

4. If the device orientation is changed. Under normal circumstances, replace the oil lens, oil plug, vent cap.

5. The reducer should always be kept clean. No dust can accumulate on the outer surface to prevent affecting heat dissipation.

6. Storage: in monotonous ventilation. Store at room temperature. When the storage period exceeds three months, anti-rust treatment should be done. Place the machine for about a year, and check whether the oil seal is aging and whether the oil product has been transformed.

/

Recommended Products

Cotact Us